Our Current E-bay Listings.

Here you will find all the items we currently have listed on e-bay.
Take a look through the list you can find lots of ATV parts.
From NEW or used, to great deals.
Thanks.

 

Welcome to the NEW 2FarOffRoad.com

3rd generation of 2FarOffRoad.com
Powered by Drupal CMS
Drupal is one of the most powerful Open Source solutions for Content Management Systems out there. It is robust, easy to use, and constantly growing and adapting to the needs of the large, worldwide community of Drupal users.

How to Embed Plogger into Drupal 6.x

I have successfully embedded Plogger into Drupal 6x and managed to make it work correctly from with in the Drupal NODE. A few line changes and it works correctly.

Using Drupal 6.15 and Plogger 1.0 RC1

TRX680FA/FGA High Idle Speed Issue

TRX680 High Idle IACV If your Rincon or other EFI Honda ATV has a High Idle at start up, then the following will help you correct the issue. The problem is that the computer controled "choke" valve is stuck. Most likely contamiated with small dirt or debrey. Follow the directions below to remove the Idle Air Control Valve (IACV) and clean it out. Honda recomends that it be replaced to stop a repeat problem.
Submitted by 2faroffroad on Tue, 02/09/2010 - 19:53

Honda Rincon Trx680 Rear Axle Replacement

- On our recent trip to WV we snapped our rear right axle on a Honda Rincon while in a mud hole. During the entire trip the CV joint had been making a popping sound when I made a sharp turn. This is a modified Rincon with a 2" lift kit with after market 26x14 BigHorn tires. Together are the cause of this issue.


Note: Image above is from a Rubicon front axle. Exmaple is the same.

*Quick Tip
If an impact gun is not available to remove the lug nuts, it is a good idea to break the lug nuts loose before raising the atv off the ground.
Step 1: Remove Wheel
We used a ATV Jack to raise the entire atv off the ground. A a normal floor jack will also work well.
Submitted by 2faroffroad on Sun, 12/13/2009 - 01:39
Syndicate content